Manual Sewage Pump, 25' cord, 1 HP, 2" Discharge, 208/230V

Description

Overview:
The Liberty Pump LE102M2-2
is a manual submersible sewage Pump with a 230V, 1HP motor and 25' quick disconnect power cord. The Liberty LE102M2-2 has a 2" NPT flanged discharge and is intended to be run using an approved liquid level control or approved motor control. The Liberty submersible sewage pump features 2-vane, semi-open impellers that allow passage of 2" solids and has a shut-off head of 36'.
The Liberty LE102M2-2 submersible sewage pump should not run dry. Be sure that when the Liberty sewage pump shuts off, at least 6" of fluid is left in the basin so the impeller remains submerged. Separate approved pump control device or panel for this submersible sewage pump is required for automatic operation. This Liberty sewage pump is constructed of heavy cast iron with a tough epoxy powder coat finish and stainless steel fasteners for years of trouble-free performance.
Features:
Rugged 2 vane, semi-open cast iron impellers
Cast iron housings and volute with all stainless and brass fasteners
416 stainless steel rotor shaft
Oil-filled, hermetically sealed motors
Built-in thermal protection on single phase models
Permanently lubricated upper and lower ball bearings
Unitized shaft seals
Single float mechanical level control with series plug for manual bypass operation-standard on single-phase automatic models
Adjustable pumping range
Quick-disconnect 25' standard power cord allows replacement of cord in seconds without breaking seals to motor
Technical Specifications:
Horsepower: 1HP
Cord length: 25'
Discharge: 2" FNPT Flanged
Solids Handling: up to 2"
Shut-off Head: 36'
Voltage: 208-230V
Amps: 8
Hertz: 60 Hz
Phase: 1
RPM: 1725
Maximum fluid temperature: 140°F
Height: 14.1"
Width: 12.6"
Weight: 64 lbs.
Minimum basin diameter: 18"
Minimum basin depth: 24"